CBEG-LJN - Standard counterbalance valve, T-2A

Counterbalance valves with pilot assist are meant to control an overrunning load. The check valve allows free flow from the directional valve (port 2) to the load (port 1) while a direct-acting, pilot-assisted relief valve controls flow from port 1 to port 2. Pilot assist at port 3 lowers the effective setting of the relief valve at a rate determined by the pilot ratio.

Technical Features

• Counterbalance valves should be set at least 1.3 times the maximum load induced pressure.


• Turn adjustment clockwise to decrease setting and release load.


• Full clockwise setting is less than 200 psi (14 bar).


• Backpressure at port 2 adds to the effective relief setting at a ratio of 1 plus the pilot ratio times the backpressure.


• Reseat exceeds 85% of set pressure when the Sun counterbalance cartridges can be installed valve is standard set. Settings lower than the standard set pressure may result in lower reseat percentages.


• Sun counterbalance cartridges can be installed directly into a cavity machined in an actuator housing for added protection and improved stiffness in the circuit.


• Two check valve cracking pressures are available. Use the 25 psi (1,7 bar) check unless actuator cavitation is a concern.


• This valve does not have positive seals on the pilot section and will pass up to 2 in3/min.@1000 psi (32 cc/min.@70 bar ) between port 2 and port 3. This is a consideration in master-slave circuits and in the leak testing of valve-cylinder assemblies.


• All 3-port counterbalance, load control, and pilot-to-open check cartridges are physically interchangeable (i.e. same flow path, same cavity for a given frame size).


• Incorporates the Sun floating style construction to minimize the possibility of internal parts binding due to excessive installation torque and/or cavity/cartridge machining variations.